Download Stock ROM / Firmware file Tecno Spark 4 Air KC1j 100%Working Download Stock ROM / Firmware file Tecno Spark 4 Air KC1j 100%Workin...
Download Stock ROM / Firmware file Tecno Spark 4 Air KC1j 100%Working
Download Stock ROM / Firmware file Tecno Spark 4 Air KC1j 100%Working
Download Tecno Spark 4 Air KC1j Stock ROM / Firmware file from this page and use it to fix all system-related issues like boot loop, corrupted memory and as well as bypass FRP and privacy protection. The Tecno Spark 4 Air belongs to the fourth generation of the Spark series
Download Tecno Spark 4 Air KC1j Stock ROM / Firmware file from this page and use it to fix all system-related issues like boot loop, corrupted memory and as well as bypass FRP and privacy protection.
The Tecno Spark 4 Air belongs to the fourth generation of the Spark series. It continues with the U-shaped notch cut-out display introduced in the flagship Phantom 9 smartphone. It even comes with a single front-facing LED flash just above the screen.
The screen itself is a 6.1-inch FullView display with a 720 x 1560 pixel resolution. It is powered by a 2.0 GHz MediaTek Helio A22 SoCQuad-Core processor and a 3GB of RAM and 32GB internal storage, expandable up to 128GB via microSD card.
Download the stock firmware for your Tecno Spark 4 Air KC1j form below and follow the instructions provided to flash and fix your bricked device.
Requirements to flash this firmware file
- Model: Spark 4 Air
- Network: 2G, 3G, and 4G Support
- SIM: Dual SIM
- Body Dimensions: 156.1 x 75 x 9.2 mm
- Display Type: IPS Dot Notch Display
- Display Size: 6.2 inches, 720 x 1560 pixels
- OS: Android 9 Pie
- Processor: 2.0 GHz Quad-core Cortex-A7
- CPU: MediaTek MT6761 Chipset
- Internal Memory: 32 GB
- RAM: 2 GB
- SD Card slot: MicroSD, up to 64GB
- Primary Camera: 13MP up with Dual LED flash
- Secondary Camera: 5MP
- WIFI: Wi-Fi 802.11 b/g/n, Wi-Fi hotspot
- Bluetooth: Yes
- GPS: Yes, A-GPS
- NFC: No
- USB: MicroUSB v2.0
- Sensors: G-Sensor, Ambient Light Sensor, Proximity Sensor, Fingerprint
- Battery Capacity: 3000mAh Li-Polymer battery
How to flash
- Download The stock firmware into your computer and extract it.
- Download SP Flash tool and extract. Also, make sure you have downloaded and installed MTK drivers.
- Now, launch the SP flash tool and load firmware scatter.
- Power off your device, click the download button on the SP flash tool and connect your Tecno Spark Air KC1j.
- The flashing will then start. wait for a couple of minutes and you will see an "OK" when the flashing is completed.
